Alexander A.Shpilman ( alexandrshpilman78@gmail.com )	Russian

 

The Generator of a "Place Power" GPP-1

The Imitator of a "Place Power" IPP-4i is good for saturation DSS by elements of atmosphere of the room, but for the research purposes frequently it is necessary to sate DSS elements small objects and liquids (water) and no more that. Naturally, there is a thought to use shielding box as described in " Shielding packing " in which to place source DSS of elements described in " The High-Voltage Generator of the "Axion Field" And of DS-state Elements ". For example, "the design is shown in a Fig.1, where on a polyethylene bobbin 4 the one-layer reel by the double enameled copper wire (wire 2 and 3 diameter of 0.1 mm and more thin) is densely reeled the coil to a coil. Inside of a bobbin the copper wire 1 is inserted. On wires 2 and 3 the difference of a voltage 100-150V (wire among themselves not closed-loop). Concerning these wires, on a wire 1 the pulsatory high voltage not less than 20 kV moves. Remains only "a polyethylene bobbin 4" to curtail into a ring and to place in shielding box.

 

As a result, we will receive a design shown on a photo which consists of a cylindrical shielding box and the high-voltage block.

 

Fig.1

 

On the second photo the shielding box with an open cover is shown. In a box it is possible to put a plastic glass with water or to place small subjects. If in the course of work of the device not to close a cover of a shielding box charge DSS elements extends on a room. So this generator can be used instead of generator IPP-3. It is thus observed much less noise and air ionization.

 

Fig.3

Naturally, the design of a bobbin shown in a Fig.1 is essentially changed. Instead of "bobbin" the plait of high-voltage wires (the Fig. 2 see) where on a wire with the iron core (rope) 1, is reeled up in one side one layer of the coil by a double wire 2 is used, and the second layer of the coil 4 is atop reeled up in an opposite direction.

 

Fig.2

On the first layer (internal) coil wires, concerning a wire 1, the negative pulsing voltage shifted on a phase amplitude in -15 KV moves. And on the second layer (external) coil wires, concerning a wire 1, the positive pulsing voltage shifted on a phase amplitude in +15 KV moves.

 

In quality a source of high-voltage pulsing voltage it is possible to take " Simple High-Voltage Source for "Simulators of a Place of Power"". A high-voltage part having replaced with the scheme shown in a Fig. 3.

 

Where:

T1 - The high-voltage transformer.

VD1, …, VD4 - the in pairs consistently connected, high-voltage diodes of type KTS121d-1 (only 8 diodes).

L - the toroidal coil magnetizing coil with the core from iron, with two iron rings on each side on which axis high-voltage wires of a plait shown on a Fig. 2 (cord) are passed. This "stopper" is intended for running off prevention on taking away wires of elements generated in plait DSS in the scheme of a high-voltage source.

On the scheme corresponding numbering of wires of connection of "plait" is shown.

 

 

Thematic Contents

CONTENTS