Russian

 

Alexandr A.Shpilman (alexandrshpilman78@gmail.com )

The Converter-NQ

Article beginning in 1N12

 

Earlier converters seen as manipulators DSS elements. What if a similar scheme to apply to change the properties of the nuclei of ordinary atoms? Try to translate the latest in state of the DS?

Protons, the "core" of atoms no balls-suns in the center of the atom. (For example, talking about this property " Foucault currents "). Protons, the "core" of the atoms have a spatial structure far beyond the atom (the size of a hydrogen atom alleged order of 10^-8 cm emits and absorbs quanta of the electromagnetic field with a wavelength of 21 cm without loss, ie the difference in nine orders, a billion time). Have both DSS and pseudo positive elements and pseudo negative of the components (spatial structure of quarks with positive and negative charge). Once these components are not split in space and usually have a very small extent (compared to DSS elements). Therefore it is necessary to modernize the design described the article " The Converter ". The latest proposed the following model:

 

Pseudo-positive a component 2 of DSS an element 1 is guided towards a conductor 4 having negative electric potential (the Fig.1 see). And pseudo-negative a component 3 is guided towards a conductor 5 having positive electric potential.

 

 

 

If we pass now through conductors 4 and 5 electric current I1 and I2 as it is shown in a Fig.2 "pseudo-charged" components of DSS elements, being extended towards to a direction of an electric current, will start to merge in two dense plaits.

 

The proposed option is instead Fig.2 have Fig.3. In conductors 4 and 5 electric currents I1 and I2 have the same orientation.

 

 

Fig .4

The question arises as "pump" energy components 2 and 3 of the proton? One option - increasing the electrical potential difference U between the conductors 4 and 5, we increase splitting between the components 2 and 3, in consequence of which increases the internal energy of the proton (for many physicists this shocking statement), respectively, and increases its mass (E=m*c^2). Now if we change the direction of the electric currents I1 and I2 in the opposite direction (on Fig.4 at time t1, where the upper diagram the change in voltage between the conductors, the lower the change of currents in them), then by self-induced increase internal impulse of components 2 and 3, even adding the internal energy of the proton. Then reduce the voltage U between the conductors 4 and 5. The splitting between the components 2 and 3 protons decreases. Reduced internal energy and the mass of the proton, and if we change direction electric currents I1 and I2 to the opposite again (at time t2), then by self-induced decrease internal impulse of components 2 and 3 is less than it has increased for the first time. This way you can pump up the components 2 and 3 until they spread on numerous larger width than the distance between the conductors 4 and 5.

If you choose two twisted copper wires in the silk insulation diameter of 0.2 mm, then alternating of current in the conductor 5 can be chosen at 300-400 mA (see middle chart on Fig.4). The electric conductor 5 is relatively conductor 4 have pulsation voltage swing of 160-200 volts. If the swing of change in the current I1 to choose half (unipolar, pulsed current), the pseudo negative component 3 acquires more energy than pseudo positive 2. As a result, the device generates a field that is less scattered around. Becomes more dense, stable. Takes on new physical properties that are yet to be explored.

If an additional electrical conductor 5 on the conductor 4 apply dc constant voltage U0 = +300 volts then the generated field is concentrated mainly in the device. Its density increases, it is tempting for physical experiments. The effect is enhanced if the twisting wires 4.5 put in cups of ferrite.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Thematic Contents

CONTENTS